Most of the time, businesses would spend lots of money to buy their forklifts. It is essential, therefore to take proper care of your machine to protect your investment into the long run. It is really a great idea to know the procedures that are undertaken during the care and maintenance of this piece of equipment.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is performing. Like for instance, if there are any knocks or misses, the equipment is faulty and this must raise several issues. Furthermore listen carefully for any squealing sounds which come from the belts as these noises will provide you with a wealth of information.
When doing maintenance, some of the main components you would have to pay attention to include the horn, safety warning devices, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components should be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals should be cleaned after the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them well. Each cell of the battery needs to be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Afterwards, check every other component of the machine like the wheels. If any kind of fault or concern is detected, be sure to address it immediately in order to make sure the equipment is working at its safest and optimum levels.