Compared to a sit-down model, the stand-up forklift unit is totally different to use. The method wherein you lift cargo and your movements are totally different. If you do not have proper training for using a stand-up unit, you can probably cause harm co-employees or to yourself. When using a stand-up unit, you must follow the proper safety regulations. There are a few basic operating standards that must be met when utilizing a stand-up unit.
To start on a stand-up model forklift, it is important to get a good feel for the controls and the steering knob. Instead of a steering wheel, the steering is handled utilizing the knob steering plate. Remember that this knob moves exceptionally fast, hence, you should get used to moving it gently in order to be sure not to over steer. The horn is situated on the control handle, as is the control for the fork movement and for backwards, forwards. The floor pedal allows the equipment to move.
When you are set to start, turn the key to start the machine. Be sure that your forks are retracted. When you are moving around the floor, the forks must be pointed slightly upwards. Never drive with the forks in their extended position. If you are traveling forwards, move the control handle forward and to make the lift move forward, step on the pedal. If you are backing up, be certain to beep your horn to warn people around you. Look behind you before stepping on the pedal so as to make sure the way is clear and safe. Then, while stepping on the pedal, pull the control handle towards you. Always stay alert and focused and make sure that you are always operating in a safe manner.
When approaching a corner with the lift truck, turn the steering knob towards the direction you are heading. Make sure to keep your foot on the accelerator and keep your hands on the control handle. When turning right, the steering knob would move in a clockwise direction while moving forward. If you are turning left, your steering knob will go in a counter-clockwise direction.
The stand-up units take some getting used to, specially if you have just used sit down models. If you take some time to know the machinery and with some training, you can handle loads quickly and efficiently in little time.